Longshine LCS-C841MC User Manual download pdf (Page 21)

1000Base-T to 1000Base-SX/LX Converter

Connecting Fiber Cable

When connecting fiber cable to a 1000BASE-FX port on

the Converter, be sure the correct type – SC or WDM -

connector is used. Follow the steps below to properly

connect fiber cabling:

1. Remove and keep the fiber port's rubber cover. When

not connected to a fiber cable, the rubber cover

should be replaced to protect the fiber optics.

2. Check that the fiber terminators are clean. You can

clean the cable plugs by wiping them gently with a

clean tissue or cotton ball moistened with a little

ethanol. Dirty fiber terminators on fiber optic cables

will impair the quality of the light transmitted through

the cable and lead to degraded performance on the

port.

3. Connect one end of the cable to the SC/WDM port on

the Converter and the other end to the SC/WDM port

on the other device.

4. Check the corresponding port LED on the Converter

to ensure that the connection is valid. (Refer to the

LED chart in next section)

Note: When inserting the cable, be sure the tab on the plug

clicks into position to ensure that it is properly seated.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 33 34

No comments

Longshine LCS-C841MC User Manual Page 21